Our three most popular 1.5 inch standard fitting lights are listed below.
These are identified with 8 notches around the outside lens. Our replacement versions thread into your 1.5 inch threaded fitting with the included installation tool.
These use a special expansion fitting. Our replacement lights will fit in the conduit and use the cable tension to secure the light in the conduit, rather than the expansion design.
The Globrite style fitting uses a quarter turn base with gasket that locks into place. Our replacements use the same light pattern and mounting method as the original.
Save
Efficient
Up to
PLD was created for one reason.
Customers are tired of paying $600+ per light from the big 3 brands, and then watching them burn out after a couple years.
Our pricing is around 1/3 of the big brands and our warranty is twice as long.
Keep the familiar color pattern for your Jandy or Pentair lights. Hayward color pattern coming soon.
No more blinding your pool guests
For maximum durability, our electronics are sealed completely. Feel the difference.
Use your existing Pentair or Jandy Automation to control the lights, or the familiar color changing pattern with other control methods.
No glare or hot spots on these lights. Just a smooth, even illumination of the pool
Our lights are resin filled to prevent cracks and leaks. Competitors keep a hollow body that causes cracking and leaks over time.
Our lights were designed from the ground up to solve the most common concerns- high replacement cost, short life span, limited features.
Tired of looking at old, dim, yellow lights? Our RGB retrofit kit replacements are a cost effective choice to create a dazzling environment.
Your pool will glow with radiance that is sure to impress your friends and family.
Want to take it to the next level? Upgrade your old on/off switch to our wifi transformer, and use your phone to control and program your lights.
Low cost competitors use a hollow light housing to reduce costs and weight.
Why? It's cheaper to make and ship.
However, this air pocket will expand and contracts with temperature changes. This expansion directly leads to micro cracking of your housing.
Over time, water leaks through the micro cracks cause the electronics to fail.
We only use fully resin filled housings to eliminate any movement of the housing and circuit.
Yes, it's heavier and more expensive to make. But we are in this business to give you a better product for less, not to cheap out on design.
